Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
U-Print plus, finish surface
Author Message

Post: #1
U-Print plus, finish surface
Hi guys,
I work with a STRATASYS U-Print plus, and I'm having problems with the finish surface. The surface is rough, like if the extrusion temperature would be too hot. (but i do not have any ajustement regarding that)
Especialy for the support material.

Any advices, on where to start my investigation.

10-16-2013 09:49 PM
Quote this message in a reply
Post Reply 

Forum Jump:

User(s) browsing this thread: 1 Guest(s)