Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
fluid to dissolve stratasys support
#1
Hello,

We just bought a stratasys uprint in an auction with a thermal circulating bath to dissolve the support matterial.

As I am new to this, does anyone have an idea what fluid I can use for this bath? And where to buy it.
The fluid from stratasys is very expensive, and I'm sure there must a cheaper solution.

Thank you
Reply
#2
... with the 'brownish' support material this could be a caustic soda solution ...
Reply
#3
(08-26-2013, 09:37 PM)VDX Wrote: ... with the 'brownish' support material this could be a caustic soda solution ...

Thank you for the information! Is there a ratio you have to respect (soda-water)?
Reply
#4
... don't know -- you have to test this with some pieces of this support material ...

Viktor
Reply
#5
(08-27-2013, 10:05 PM)VDX Wrote: ... don't know -- you have to test this with some pieces of this support material ...

Viktor

Thank you. I used 100g/kg of caustic soda at 60-70 °C and it works very well. Thanks
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)