Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
What slicing program do you recomend
#3
(02-23-2014, 07:37 AM)RapidProtoCo Wrote: Does any one know of good software for Linux, Im using Ubuntu, and Id love to get my Linux box printing.

http://www.RapidProtoCo.com

Reprap magazine has a comparison of slicing software here: http://reprapmagazine.com/issues/1/. Slic3r, at the very least, runs on Linux.

At least two of the popular open-source printer control packages will run on linux - Repetier Host and pronterface. Slic3r comes packaged with both of these, so there's your tool chain right there.
Reply


Messages In This Thread
What slicing program do you recomend - by art3d - 01-08-2014, 04:30 AM
RE: What slicing program do you recomend - by 3dkarma - 02-24-2014, 07:15 PM
RE: What slicing program do you recomend - by aandbrendering - 02-25-2014, 11:31 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)