Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Basic Printing with PLA Filament
I am in need of assistance on the very basics of 3D printing. I have tried to print using both Makerware and Replicator G software. Am printing using PLA filament on Kapton tape covered bed (bed heated to 110 Deg Celsius). After aligning bed, halfway through the print the extruder nozzle catches the printed object and starts dragging it around the bed. PLA filament temp is 230 Deg Celsius. Could anyone please tell me what I am doing wrong?

Messages In This Thread
Basic Printing with PLA Filament - by grarobad - 12-04-2013, 01:12 PM
RE: Basic Printing with PLA Filament - by art3d - 02-21-2014, 11:13 AM

Forum Jump:

Users browsing this thread: 1 Guest(s)