3ders.org Forums › Desktop 3D Printers › Troubleshooting
Printing Large model

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Printing Large model
actsalgado11
Unregistered
 
#1
08-31-2013, 04:42 PM
Printing at 100% infill, bottom warps, and some cracks appear, any suggestion or tips to avoid this kind of failure?
Reply


Messages In This Thread
Printing Large model - by actsalgado11 - 08-31-2013, 04:42 PM
RE: Printing Large model - by MiniFabrikam - 09-01-2013, 09:24 AM
RE: Printing Large model - by art3d - 11-16-2013, 11:44 AM
RE: Printing Large model - by Cereus Graphics - 10-19-2013, 07:31 AM
RE: Printing Large model - by art3d - 12-12-2013, 07:10 AM
RE: Printing Large model - by OliveFrogs - 01-16-2014, 09:59 PM
RE: Printing Large model - by art3d - 01-17-2014, 02:12 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)