Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Printing Large model
#7
We found the best thing to use is Circuit board protective spray. Its basically acrylic lacquer. When the heatbed cools down a bit it just pops off. We have printed 25mm tubes 350mm long with a 5mm brim and they didn't fall over.

Another Tip I have. 3M have a product that is used to print on. The thickest window tint film is the same material and is a lot cheaper. So take your build plate down to the glass tinting place and give that a go if you can't get some spray.
Reply


Messages In This Thread
Printing Large model - by actsalgado11 - 08-31-2013, 04:42 PM
RE: Printing Large model - by MiniFabrikam - 09-01-2013, 09:24 AM
RE: Printing Large model - by art3d - 11-16-2013, 11:44 AM
RE: Printing Large model - by Cereus Graphics - 10-19-2013, 07:31 AM
RE: Printing Large model - by art3d - 12-12-2013, 07:10 AM
RE: Printing Large model - by OliveFrogs - 01-16-2014, 09:59 PM
RE: Printing Large model - by art3d - 01-17-2014, 02:12 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)