Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Please recommend a 3D printer for research please
#1
Hello, I got a Makerbot Replicator 2. I don't like it as it fails quickly after purchase. Print quality is also not that good. I can see lines of layers and small holes even for screws M2 size cannot be printed nicely. I heard that Up Plus can print good quality stuff but the print volumn is too small. The print speed is also slow. I then considered the CubeX Trio. Read three users complaining that the software crashes often and the print quality is not as good as the cheaper UP Plus. I also consider the STARATASYS uPrint Plus but don't hear much about it. How is it compared with the ones I mentioned anyway? My university does not mind paying more. We want excellent print quality, speed similar to the Replicator 2 is ok and large build volume. What suggestions do you have?
Reply


Messages In This Thread
Please recommend a 3D printer for research please - by 3dprinteruser - 05-22-2013, 06:07 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)