Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Experience of purchasing a 3D printer by Bits From Bytes
#3
I'm leaning toward a MakerBot Replicator 2 for the "rough drafts" prints of my model cars, but may end up sending the .stl file to a service to get mirror smooth surfaces on the 3D prints.
Reply


Messages In This Thread
RE: Experience of purchasing a 3D printer by Bits From Bytes - by burgener - 04-08-2013, 06:29 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)