Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Some questions
#6
(03-20-2013, 06:45 PM)Marcus Wrote: Perhaps the wrong place to ask for it, but as it's a 3D / 3D Prnting forum, how about some 3D-Printer tools?

(calculating how many mm filament are needed for x cubic milimenters, converting cubic volume units (mm, in, cm,...), how many layers will be in a print with Y height and 0.x mm layers... Stuff like that :-) )

not bad.. i can think about it Smile now I try to ask this question in a good section in this forum Wink

lol i don't know where XD
Reply


Messages In This Thread
Some questions - by fabius - 03-07-2013, 10:13 PM
RE: Some questions - by Marcus - 03-07-2013, 10:41 PM
RE: Some questions - by fabius - 03-08-2013, 11:16 AM
RE: Some questions - by fabius - 03-20-2013, 06:00 PM
RE: Some questions - by Marcus - 03-20-2013, 06:45 PM
RE: Some questions - by fabius - 03-21-2013, 10:40 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)