Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Best software for a beginner?
#3
For 3d modeling fun, you should try Sculptris, as well. the user interface is fairly intuitive, and made by the same folks that make Zbrush, a higher end 3d modeling program. It's not for calculating paths, or actual manufacturing of any kind. Just for 3d graphics manipulation. But it's fun to play with.
Reply


Messages In This Thread
Best software for a beginner? - by imagiqc - 02-14-2013, 09:27 PM
RE: Best software for a beginner? - by Zephyrean - 02-28-2013, 01:21 PM
RE: Best software for a beginner? - by imagiqc - 02-28-2013, 10:22 PM
RE: Best software for a beginner? - by rudalf - 03-04-2013, 10:22 AM
RE: Best software for a beginner? - by VDX - 03-05-2013, 09:33 AM
RE: Best software for a beginner? - by Marcus - 03-06-2013, 12:36 AM
RE: Best software for a beginner? - by Pecos Bill - 04-14-2013, 04:12 PM
RE: Best software for a beginner? - by Polytech - 04-25-2013, 01:58 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)