Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
CNC Mill conversion help
#2
... I'm sometimes using my old Isel-CNC-mill with 550x500x90mm working area as RepStrap too by switching the original controller for an Arduino +RAMPS 1.2, heated bed and a Wade's type extruder with modified hot-end.

My Z-height is only 90mm, but I can use long tools without problems - here you can see a photo with the spindle and a really long dispenser side by side fixed to the stage:

http://reprap.org/wiki/Paste_Dispenser

Viktor
Reply


Messages In This Thread
CNC Mill conversion help - by ElliotHC - 02-05-2013, 01:11 AM
RE: CNC Mill conversion help - by VDX - 03-05-2013, 09:28 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)